Table of Contents
Advertisement
Maintenance menus at-a-glance
Item
For carrying out maintenance on the carriage and station periphery.
Carriage Out
(
P.4-10)
Nozzle Wash
(
P.4-15)
Pump Tube Wash
Maintenance cover
(
P.4-12)
Custody Wash
(
P.4-12)
REPLACE WIPER
(
P.4-24)
For printing using another nozzle, if nozzle wash and so forth fail to effect recovery from nozzle missing, etc.
Print
Nozzle Recovery
Entry
(
P.4-16)
Check
Reset
For having the various maintenance functions executed automatically. Set the execution interval for each
maintenance function.
Auto Maint. (
P.4-
Refresh
19)
Cleaning
Sub Tank (
P.5-4)
Charge Ink (
P.4-20)
Replace Ink Tank (
P.4-26)
Waste Expired Ink (
)P.4-25
Tank Calibration (
)P.4-28
Set value
Moves the carriage out, for carrying out cleaning of the cap periphery,
head, wipers, etc.
Soaks the nozzle surfaces in maintenance cleaning fluid, for carrying
1 to 15min
out recovery from nozzle missing or bent.
Executes washing of the suction pump tubes.
Carried out when the machine is going to be out of use for an extended
1 to 15min
period. Washes the nozzles and tubes beforehand, to keep the
machine in fine condition.
Used when replacing the wiper. If the wiper is replaced, the number of
times the wiper was used that is managed in this device is reset.
Used to print a pattern and to check and/or register clogged nozzles.
Registers the faulty nozzle identified by "Print".
Checks recoverable printable conditions.
Resets a registered faulty nozzle.
OFF/Lv.1/
For setting the activation interval for refresh.
Lv.2/Lv.3
For setting the activation interval for head cleaning.
OFF/Lv.1/
When set to other than "OFF", you can set the cleaning type (Soft /
Lv.2/Lv.3
Normal / Hard).
Used to charge ink and to solve the problems including ink errors and
nozzle missing .
Used when ink cannot be automatically charged, or if you want to
charge ink after confirming the contents of the IC ship.
Used to replace a expired ink tank and to reset the ink charge
information.
Discard the expired ink and reset charged information.
Make the correction of the weight balance of the ink supply unit.
Chapter 4 Maintenance
Description
4
2
4-9
Advertisement
Table of Contents
