Washing The Ink Discharge Passage; When The Machine Is Not Used For A Long Time (Custody Wash) - MIMAKI Tx500P-3200DS Operation Manual

Table of Contents

Advertisement

Chapter 4 Maintenance

Washing the Ink Discharge Passage

Wash the ink discharge passage on a regular basis (once
every 2 - 3 months) to prevent ink coagulation from
clogging the passage.
1
Press the
(MAINT) in LOCAL.
• The Maintenance menu appears.
2
Press
and press the
• The carriage moves onto the platen.
• Dry suction operation is performed repeatedly
until the washing work is completed.
3
Open the lower part of the right side front
cover.
(1) Remove the screws of the right side front
cover (for two positions).
(2) Hold the upper of the lower part of the right
side front cover and pull it to the front.
• Open the lower part of the right side front cover
with the supplied screwdriver.
Screw
4
Suction the cleaning solution into a
syringe and squirt about three syringes
worth of solution into each cap.
4-12
key and press
to select "Disway Wash",
key.
Carriage
Lower part of
the right side
5
Close the lower part of the right side front
cover, and press the
• After running a dry suction for a certain period of
time, the screen returns to step1.
When the Machine Is Not Used for a
Long Time (Custody Wash)
When the machine is not going to be used for a week or
more, use the cleaning function for custody to clean the
head nozzles and ink discharge passage. After this, keep
the machine in custody.
Check the items on the right beforehand.
Is "NEAR END" or "INK END" displayed?
• The cleaning solution or ink is absorbed when the nozzles
are washed.
At this time, if the state of "no ink" or "almost no ink" is
detected, the nozzle washing operation cannot start.
• Refill ink.
• Be sure to use the dedicated cleaning Liquid 03
MAINTENANCE KIT (ML003-Z-K1).
1
Press the
(MAINT) in LOCAL.
• The Maintenance menu appears.
2
Press
to select "Custody Wash",
and press the
• The carriage moves onto the platen.
• Until wiper/ bracket cleaning is competed, "Please
clean the wiper." is displayed on the screen. After
the work up to the step 5 is completed, press the
[ENTER] key.
key.
key and press
key.
Carriage

Advertisement

Table of Contents
loading

Table of Contents