Table of Contents
Advertisement
3
Remove the pinch roller.
• Loosen the knob screws (2 points) and pull them
towards you.
4
Wipe the surface of the grit roller using a
brush to remove any dirt.
• Lightly brush the surface of the grit roller several
times.
• Rotate the grit roller with your hand to make sure
you brush the entire circumference of the roller.
• If the brush gets dirty, wipe it with a dry cloth.
Grit roller
• Make sure you use a resin brush to clean the grit
roller. If you wipe it with a cloth or paper, lint sticks
to the uneven sections. Also, using a hard,
metallic brush can damage the surface of the grit
roller.
• Do not use water or cleaning solution when
brushing the roller. This can cause rusting.
5
Remove dirt from the surface of the pinch
roller.
• Wipe the surface of the pinch roller with a cloth to
remove any ink stains.
Remove ink
stains
6
Install the pinch roller.
• When installing the pinch roller, align the convex
section on the installation side, and then install.
7
Turn on the machine and check that it is
operating correctly.
(1) Press the
(2) Press
(3) Press the
• The carriage moves onto the platen.
(4) Open the front cover.
(5) Push the carriage with your hand to move it
to the left edge, and then check that the
carriage and the pinch roller do not obstruct
each other.
• If the carriage and the pinch roller obstruct
each other, re-install the pinch roller, and
then check that there is no obstruction.
(6) If there are no problems, close the front
cover.
(7) Press the
• After the initial operations, the media
selection screen is displayed.
Chapter 4 Maintenance
key in Local mode.
, and select [Carriage Out].
key.
key.
4-5
4
2
Advertisement
Table of Contents
