Setting A Roll Media - MIMAKI Tx500P-3200DS Operation Manual

Setting a roll media

Prepare for the take-up device first
Prepare for the take-up device before setting the roll
media.
• Handle the roll shaft with care, since it is very
heavy with media. To avoid an accident or injury,
be sure to grip the handles on both ends.
Handle
1
Remove the roll shaft on the take-up
device at the front of this machine.
Cover(left)
(1) Loosen the cover fixing screw attached to the
cover of left of take-up device and unlock the
AMF lock by sliding it.
(2) Open the covers.
Cover(right)
Roll shaft
Cover fixing
screw
AMF lock
Chapter 2 Basic Operation
(3) Loosen the cover fixing screw attached to the
cover of left of take-up device and unlock the
AMF lock by sliding it.
(4) Open the covers.
• When remove the AMF lock, the bottom cover will
be lowered.
(5) Remove the roll shaft.
2
Remove the roll holders.
• The roll holders are on both for the right and left of
the roll holder. Remove both with the procedures
below:
(1) Loosen screws (1 each on the right and left)
with supplied ratchet handle.
(2) Remove the holders.
AMF under cover
2
2
2
Ratchet handle
Roll holder
2
2-7