Table of Contents
Advertisement
Chapter 3 Setup
Function name
Auto Cleaning
Cleaning
Interval
Type
Cln.BeforePrint
Separation
Nozzle Check
Check
Interval
Auto Nozzle
Maintenance
(
P.3-12)
Cleaning Type
RETRY COUNT
Auto Nozzle
Recovery
Judgement
Condition
Separation
Feeding Set
Interval Wiping (
P.3-15)
Head Gap (
P.3-15)
Setup Reset (
P.3-26)
*1. The underlined has been set as default.
*2. This is the setting value to be used for printing when setting value is not specified at the RIP software (Host) side, or, you give priority to the setting value at
the machine side.
3-4
*1
Set value
ON / OFF
Length
0.1 to 20.0 to 100.0 m
File
1 to 10 to 1000
Time
10 to 120 min
Soft, Normal, Hard
10 to 720 min/ OFF
OFF / RIP Separation
ON / OFF
Length
0.1 to 30.0 to 100.0 m
File
1 to 30 to 1000
Time
10 to 30 to 120 min
Soft, Normal, Hard, Auto
0 to 3
ON / OFF
1 to 10 to 100 / OFF
OFF / RIP Separation
ON / OFF
3 to 255 min, OFF
1.5 to 2 to 7.0mm
The configuration in the settings 1-4 can be reset individually.
When no
instruction
from RIP
*2
exists
Sets the automatic cleaning operation for the head
performed before or during printing.
Performs cleaning at intervals of the set length.
Performs cleaning whenever the set number of
files has been processed.
Performs cleaning at intervals of the set time.
Sets the type of cleaning to be performed.
Performs cleaning before printing start if the
specified time has passed since the previous
printing completion time.
According to the instruction from the RIP, the cleaning is
performed at the separation of the image.
Set it to ON to perform nozzle check automatically.
Performs nozzle check at intervals of the set
length.
Performs nozzle check whenever the set number
of files has been processed.
Performs nozzle check at intervals of the set time.
Sets the type of cleaning to be performed when
any nozzle missing error is detected.
If "Auto" is selected, the machine performs an
optimum cleaning according to the nozzle
recovery state.
Performs recovery operations for missing nozzles
by the set number of times.
Set it to ON to perform nozzle recovery
automatically.
Sets the number of detected missing nozzles in
each head line and color that leads to
determination of a "nozzle missing" error.
When set to OFF, the machine performs no nozzle
check.
According to the instruction from the RIP, the nozzle check is
performed at the separation of the image.
Set whether or not feed during the maintenance.
Sets the wiping operation performed after printing
is completed.
Sets the head gap.
Outline
Advertisement
Table of Contents
