Prepare Color Fixation Device - MIMAKI Tx500P-3200DS Operation Manual

Chapter 2 Basic Operation
Emergency stop
The emergency stop switch is attached to the heater (1 point) and the printer side (5 points).
The emergency stop switch on the printer side is effective only when the printer is activated.
If you feel danger, please push the switch near you.
For details, refer to

Prepare Color Fixation Device

Control Panel
Operation of the color fixation device is performed on the operation panel of the color fixation device.
The operation panel of the color fixation device adopts a touch panel. Please tap the screen and operate.
TOP screen
① ②
⑦
① Status indication
The following eight types of status are displayed.
• OFF
• WAITING (Waiting)
• READY (Reached Coloring temperature)
• STAND BY (Standby temperature)
• HEATING (Heating)
• COOLING (Cooling)
• ERROR (Error occurring)
• MAINTE (Turning on the power, during maintenance)
② Interlock control display
The following two interlocking control modes are displayed.
• LOCAL
• REMOTE
Tap to switch.
However, it can not be used when the ERROR is shown on the display.
③ Time Display
The current time is displayed.
④ Screen transition 1
Tap to move to the motion setting screen.
⑤ Screen transition 2
Tap to switch to the temperature chart screen.
⑥ Setting menu
Various setting screen is displayed.
⑦ Temperature display
The following two types of temperature are displayed.
• Current temperature
• Set temperature
By tapping, the set temperature can be changed.
2-20
P.1-14「About the emergency switch?
③
④
⑤
⑥