Set The Network; Setting Event Mail Function - MIMAKI Tx300P-1800 Operation Manual

Set the network

You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://mimaki.com/download/).
Press (MENU)
1
in LOCAL.
• MACHINE SETUP MENU will be displayed.
Press (>>) twice.
2
Press to select "NETWORK",
3
and press the
Press the
4
• "CHECK IP ADDRESS" will be selected.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
• After connecting with the network, it takes time until
the IP address is determined. If the IP address has
not been determined, "0.0.0.0" is displayed.
Press , and press the
5
• "CHECK MAC ADDRESS" will be selected.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
Press , and press the
6
• "DHCP" will be selected.
Press to select a set value, and
7
press the
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
Press , and press the
8
• "AutoIP" will be selected.
Press to select a set value, and
9
press the
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
Press , and press
10
• "IP ADDRESS" will be selected.
Press to select a set value, and
11
press the
• Set value : ON/ OFF
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
(twice)
key.
key.
key.
key.
key.
key.
key.
.
key.
Chapter 3 Machine setting
Press .
12
• The setting items DEFAULT GATEWAY, DNS
ADDRESS and SUBNET MASK will be displayed.
• Both of DHCP and AutoIP is OFF, you can set
DEFAULT GATEWAY/ DNS ADDRESS/ SUBNET
MASK. For other than above, proceed to the Step
14.
Press several times to select setting
13
item, and press the
Press to select a set value, and
14
press the
Press the
15
end the setting.
• To reflect network setting, once turn off the power
supply and turn it on again.

Setting event mail function

Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://mimaki.com/download/).
• Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
Enable the event mail function
Press (MENU)
1
in LOCAL.
• MACHINE SETUP MENU will be displayed.
Press (<<) .
2
Press to select "EVENT MAIL",
3
and press the
Press the
4
• "MAIL DELIVERY" will be selected.
Press to select "ON", and press
5
the key.
key.
key.
key several times to
(twice)
key.
key.
3-19
1
2
3
4
5
6