MIMAKI Tx500P-3200DS Operation Manual page 56

Chapter 2 Basic Operation
6
Exit REMOTE mode.
(1) Touch the
The status changes from [WAITING] to [MAINTE].
When you do not control the color
fixation device from the printer
1
Turn on the main power supply of color
fixation device.
MAINTE
25.0
180.0
2
Start LOCAL mode.
(1) Touch the
The status changes from [MAINTE] to
[WAITING].
WAITING
3
Turn on heater.
(1) Touch the
The operation screen is displayed.
(2) Touch the
The heater turns ON and the status changes
from [WAITING] to [HEATING].
HEATING
You can go back to the previous screen by pressing
button.
2-26
button.
button.
button.
of the [HEATER].
4
Start printing.
• When the furnace temperature stabilizes at the
set temperature, the status changes from
[HEATING] to [READY].
READY
(1) Adjust the opening
plate.( P.2-27)
(2) Send print data from computer to printer.
Printing will start.
• If you leave the heater on without starting printing,
the heater will turn off automatically.
• For the time to turn off the heater, refer to
P.2-24「Set off timer」
5
Turn OFF heater.
(1) When printing is completed, touch the
button.
The operation screen is displayed.
(2) Touch the
The heater turns off and the status changes
from [READY] to [COOLING].
COOLING
You can go back to the previous screen by pressing
button.
• When the furnace temperature falls below 60
degree C, the status changes to [COOLING] →
[WAITING].
WAITING
59.0
180.0
6
Exit LOCAL mode.
(1) Touch the
The status changes from [WAITING] to
[MAINTE].
at the aperture
of the [HEATER].
button.