Preparing The Color Fixation Device; Name And Function Of Each Part Of The Color Fixation Device - MIMAKI Tx500P-3200DS Operation Manual

Preparing the Color Fixation Device

This machine performs a consistent dry to color fixation process for after printing. Additionally, make sure you perform a
test for each media type (fabric) in advance to realize optimum color quality.
You need to set the heater temperature for the color fixation device before printing.

Name and Function of Each Part of The Color Fixation Device

Pilot lamp
Displays the state of the color fixation device.
Off: Main power OFF / Heater OFF.
Green blinking: Heater is warming up
(HEATING).
Green lit: Ready for coloring (READY).
Red blinking: Cover is open.
Red lit: Error.
Emergency switch
Emergency stop the heater and printer by
pressing the switch in case of emergency.
To cancel, please turn to the right to release
the switch and reset from the touch panel.
Main power switch
Turn ON / OFF the main power supply
of color fixation device.
Turn on / off the color fixation device
• When turning on the main power supply, please do not touch the heater part.
• When performing maintenance, be sure to turn off the main power.
• When turning on the main power supply, please do not block the filter part and the punching part.
1
Turn on the main power switch
• Turn the main power switch to the "ON" position.
Chapter 2 Basic Operation
Heater ON/OFF switch
Turn on / off heater on local control.
LED blinking: Heater is waiting
(WAITING). Turn the switch to the right
to turn on the heater.
LED lit: Heater is ON. Turn the switch
to the left to turn off the heater.
Operation panel
Perform various operations of the
heater.
Filter
Punching section
2
2
2
2
2-19