MIMAKI Tx500P-3200DS Operation Manual page 43

19
Open the hood cover of the coloring
heater.
20
Pull out the edge of the media until it
reaches the top part of the color fixation
device.
Pull out the edge of the media to cover a length
of approximately 30 mm, and place it on top of
the aperture plate on the color fixation device.
• If you pull the edge of the media too far out, it will
not fit into the color fixation device, and you will
not be able to guide the media.
If you pull the edge too far out, use the back feed
function or a similar method to adjust the amount
of media.
Approx. 30 mm
Side view
Front
Aperture
plate
Pulling roller
Aperture plate
Media
Back
Opening at the
aperture plate
Approx. 30 mm
Chapter 2 Basic Operation
21
Use the jig to pass the media through the
opening at the aperture plate.
• Use the following jig:
(accessory box 1)
Auxiliary moving rollers
(1) Insert the jig into the central part of the color
fixation device until the auxiliary moving
rollers touch the surface.
(2) Press the jig gently against the pulling roller.
(3) Move the jig to the right and left, and slowly
insert the edge of the media into the color
fixation device. Move the jig gradually, and
completely insert the media into the opening
at the aperture plate.
• If the jig hits the screws or some other parts, do
not push the jig inside by force, but rather pull it
out first, move it, and then try to reinsert it.
(3)
(1)
Side view
Guiding fabric jig
Front
Auxiliary
moving rollers
Aperture plate
Opening at the
aperture plate
Guiding fabric jig
Handle
(2)
(3)
(2)
Back
Pulling roller
Media
2-13
2
2
2
2