Table of Contents
Advertisement
3
Open the lower part of the right side front
cover.
(1) Remove the screws of the right side front
cover (for two positions).
(2) Hold the upper of the lower part of the right
side front cover and pull it to the front.
• Open the lower part of the right side front cover
with the supplied screwdriver.
Lower part of the right
side front cover
Screw
4
Clean the wiper and the bracket, and press
the
key.
(1) Open the right maintenance cover then pull
out it by holding projections at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance. (ML003-Z-K1: Cleaning
Liquid 03 MAINTENANCE KIT)
Wipe off so
•
that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
Projection
5
Clean the cap rubber and cap rubber
cover.
• Wipe off the ink sticking to the cap rubber and cap
rubber cover with a clean stick dipped in cleaning
solution for maintenance. Wipe off so that
cleaning solution for maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
Cap rubber
6
Press
key.
• Until washing liquid is filled, "Fill the liquid." is
displayed on the screen. After the work up to the
Step 8 is completed and you close the front cover,
press the [ENTER] key.
7
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before
the solution overflows from the cap.
8
Close the lower part of the right side front
cover, and press the
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves onto the platen.
9
Press
to set the resting time, and
press the
key.
• The nozzles are washed.
• When the nozzles have been completely washed,
the head moves onto the platen.
Chapter 4 Maintenance
Cap rubber cover
key.
4-13
4
2
Advertisement
Table of Contents
