MIMAKI Tx500P-3200DS Operation Manual page 134

Chapter 5 Troubleshooting
Message displayed in LOCAL
Message
INK ERROR
InkOverflow : MMBBYYKK
TANKlevelH : MMBBYYKK
TANKlevelL : MMBBYYKK
SUPPLY INK : MMBBYYKK
REPLACE INKTANK : MMBBYYKK
Take-UP CoverOPEN
Take-UP WRONG
Take-UP LimitDETECT
Feeding WRONG
5-8
Cause
An ink error occurred.
Ink has entered the air tank.
The sub tank sensor High does not change
though a certain amount of ink has been
consumed.
The sub tank sensor Low does not change
though a certain amount of ink has been
consumed.
Ink could not be supplied to the subtank.
Time to replace the ink tank of the dis-
played color
(A certain period has passed since the start
of use of the ink tank.)
Detected a cover open of the media take-
up device.
An abnormality occurred in the take-up sta-
tus of the media take-up machine.
The control limit sensor of the media take-
up machine was detected.
An abnormality occurred in the feeding sta-
tus of the media feeding machine.
Measures
• Check the ink bottle for the supply path
corresponding to the indicated color.
• Perform "SUBTANK" of the mainte-
nance. ( P.5-4)
Even if you perform, it may be displayed,
contact your local distributor to call for
service.
• Perform "SUBTANK" of the mainte-
nance. ( P.5-4)
Also make sure the ink remaining in the
ink bottle. ( P.1-10)
Even if you perform, it may be displayed,
contact your local distributor to call for
service.
• Perform "Replace Ink Tank" of the main-
tenance. ( P.4-26)
• The ink charge information is also reset.
After replacing the ink tank, charge the
new IC chip and refill ink. (
• Close the cover.
• Check if the media setting is set to ROLL
when the take-up device is not used.
• Check if the taking-up direction switch
and the taking-up manual switch are set
correctly.
( P.2-15)
• Check that the media is set on the media
take-up machine correctly.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time
when the error occurred.
• Check if the media can be fed correctly in
the jog operation.
• Lower the position of the tension bar at
the take-up side.
Even if you lower the position, if the same
message is displayed, contact a distribu-
tor in your district, our office or our call
center.
• Check if the media setting is set to ROLL
when the feeding device is not used.
• Check if the taking-up direction switch
and the feeding manual switch are set
correctly.
• Check that the media is set on the media
feeding machine correctly.
• Turn ON and OFF the manual switch, and
raise the tension bar to a correct position.
• Feed the media in the jog operation in the
direction reverse to that used at the time
when the error occurred.
P.1-10)