Table of Contents
Advertisement
Checking the Logs
1
Tap [F1] (Screen transition 1).
• Displays the various settings screens.
2
Tap [LOG].
• The Check Logs screen is displayed.
• Use the up and down keys to switch between logs.
The up key moves you backwards through the logs.
The down key moves you forwards through the logs.
About a cancellation of ERROR of the
color fixation device
When the status of the color fixation device becomes
[ERROR], its error status can be cancelled by canceling
the error status.
Cancellation of ERROR
1
Tap [F1] key.
ERROR
2
Tap [CHECK] key.
Chapter 2 Basic Operation
3
Tap [RES] key.
• If it cannot be cancelled even by pushing [RES],
turn off the main power once.
• In case of THERMALSTAT error, it cannot be
cancelled until the inside temperature decreases.
Warming Up
• It takes about 40 minutes from when turning on the
heater until coloring becomes possible.
• You can warm the coloring machine by turning on the
heater in local mode in advance.
• You can change to control from the printer by changing
from local to remote in the middle.
Media Setting
Set media according to the procedure of Chapter 2
P.2-4「Setting a Media」
Adjusting the opening at the aperture
plate
This adjustment allows you to set the opening to the ideal
size in order to maintain a constant temperature inside the
furnace of the color fixation device, and ensure high
quality colors.
Be sure to adjust the opening after setting the media or
changing the temperature settings.
Adjust the opening when the following conditions are
fulfilled.
• The temperature inside the furnace has stabilized at
the set temperature, and the status on the operation
panel has changed from [H] to [R].
• The media has been set.
Opening at the aperture plate
2-27
2
2
2
2
Advertisement
Table of Contents
