Setup Menu Table - MIMAKI Tx500P-3200DS Operation Manual

 Screen transition when (ADJUST) key is pressed
When adjustment functions (Feed Comp./ Prop Pos. Correct) are performed, the Adjust menu can be displayed easily
without selecting [MENU]-[Setup] from Local. Press the [SEL] key to display "ADJUST" for [FUNC1], and then press the
[FUNC1] key.
Local <Setup 1> 12:00
1340mm
CONSTANT
179° C/180° C
TEST PRINT /
MENU REMOTE
CLEANING

Setup menu table

• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : DRYING Time/ Vacuum Fan
• When you operate the machine according to the contents specified with the RIP software, set each item to "Host" when
registering this machine type. When you set it other than "Host", the machine operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name
Feed Comp.( P.3-6)
Drop Pos. Correct ( P.3-7)
Color fixation
device EXTERNAL HEATER
( P.3-8)
Logical Seek ( P.3-8)
Overprint ( P.3-9)
Drying Time
Scan
( P.3-9)
Margin/L ( P.3-9)
Margin/R ( P.3-9)
Refresh ( P.3-9)
Refresh Left ( P.3-10)
Drying fan ( P.3-10)
Feed Speed ( P.3-10)
Auto/ Manual
MAPS4 Speed
( P.3-11)
Manual
Smoothing
Lv.
Adjust Adjust
Feed Comp. > Feed Comp.
PropPos. Correct > PropPos. Correct
*1
Set value
-9999 to 0 to 9999
-40.0 to 0 to 40.0
ON/OFF
Host / ON/OFF
Host / 1 to 9
Host /0.0 ~ 9.9 sec
Host /-10 to 0 to 85mm
Host / Lv.0 to Lv.3
ON/OFF
Host / 10 to 200% (in
increments of 10%)
Host / 10 to 200 %
50 to 100 %
0 to 25 to 100%
>
>
When no
instruction
from RIP
*2
exists
Used to print a pattern for correcting a media-
feeding rate and correct it.
Used to adjust the dot position in go and return
printing.
Sets ON/OFF of the external heater.
Sets the scan movable area during printing.
Sets the number of layers in which ink is to be
1
applied.
0 sec Sets the drying time of ink per scan.
Sets a non-printing area along the right and left
edges of the media.
Sets the interval of refresh performed during
Lv.3
printing.
Depending on the type of ink to be used, if the
flushing operation on the capping station can not
OFF
fully refresh the head, you can also set to allow the
flushing operation on the left side.
Normal
Sets the power for the drying fan.
speed
Changes the media feeding speed in printing.
Perform setting to reduce stripes between passes.
Chapter 3 Setup
Outline
3-3
3
2
2