Table of Contents
Advertisement
Chapter 3 Setup
5
Press
(Setup 1 to 4), and press
• Save confirmation screen will be displayed.
6
Press
• Settings of Temporary will be saved to the location
selected in step 5.
7
Press
the setting.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
1
Press the
Local.
2
Press
be reset and press the
• Setup menu will be displayed.
3
Press the
4
Press
and press the
• Confirmation screen of reset settings will be
displayed.
5
Press
the setting.
3-6
to select the save location
key.
key.
key several times to end
key in
(MENU)
to select SETUP 1 to 4 to
key.
(<<).
to select "Setup Reset",
key.
key several times to end
Setting of Media Correction
Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
• Be sure to perform feed correction each time
before printing. The media feed amount may vary,
depending on the remaining amount of the roll
media.
• If use by setting the media to Narrow roll holder,
rewind the roll media by hand and set without
slack.
There may not be accurate to correct the feed
amount.
• On completion of [MEDIA COMP.] during use of a
roll media, the media returns to the printing origin.
When a media is set on the narrow roll holder,
slack occurs in the roll media on the backside of
this machine.
Before printing, take up the slack in the roll media
by hand; a loose roll media can result in an inferior
image quality.
• When printing with a take-up device, set the media
first and then perform media correction.
• When printing without using the take-up device,
feed the media until the media reaches the floor
before performing the correction. Otherwise, the
feed amount may not be adjusted normally.
A pattern for media correction is printed and a media-
feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
1
Setting a Media (
2
Press the
Local.
3
Press
to select SETUP 1 to 4, and
press
key.
• Setup menu will be displayed.
4
Press
to select "Feed Comp." ,
and press the
5
Press the
correction pattern.
P.2-4)
key in
(MENU)
key.
key to print the
Advertisement
Table of Contents
