Flow Of Color Fixation Device Operation - MIMAKI Tx500P-3200DS Operation Manual

1
Touch the button on the top screen.
• The setting menu will be displayed.
2
Touch the [Timer Setting] button.
• The timer setting screen is displayed.
3
Set off timer time.
• Touch the value of [Automatic Heater Off Timer]
and set the time. (1 to 60 minutes).
• The setting time of [Automatic Heater Off Timer] is
linked with the setting time of [Heater OFF] on the
printer side.
Flow of color fixation device opera-
tion
When you control the color fixation
device from the printer
1
Turn on the main power supply of color
fixation device.
MAINTE
25.0
180.0
2
Start REMOTE mode.
(1) Touch the
The status changes from [MAINTE] to
[WAITING].
WAITING
button.
Chapter 2 Basic Operation
3
Send print data from computer to printer.
• For the method of sending data, please read the
operation manual of the output software.
• The heater turns ON and the status changes from
[WAITING] to [HEATING].
HEATING
4
Start printing.
• When the furnace temperature stabilizes at the
set temperature, the status changes from
[HEATING] to [READY], and printing starts
automatically.
• If you have not adjusted the opening at the
aperture plate ( P.2-27
described in "When you do not control the color
fixation device from the printer (
The automatic printing function is available when
all of the three conditions below are fulfilled.
•You have adjusted the opening at the aperture
plate( P.2-27).
•You have not replaced the media since the last
printing operation.
•You have not changed the temperature settings
since the last printing operation
READY
5
Finish printing.
• When printing is finished, the heater turns off
automatically and the status changes from
[HEATING] to [COOLING].
If the standby time is set in the printer setting, the
status changes to [HEATING: S].
COOLING
• When the furnace temperature falls below 60
degree C, the status changes from [COOLING] to
[WAITING].
WAITING
59.0
180.0
), follow the procedure
)"".
P.2-26
2-25
2
2
2
2