Table of Contents
Advertisement
Setup MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : DRYING Time/ Vacuum Fan
• When you operate the machine according to the contents specified with the RIP software, set each item to "Host" when
registering this machine type. When you set it other than "Host", the machine operates according to the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name
Feed Comp. (
P.3-5)
Drop Pos Correct (
P.3-6)
PRE
Heater
PRINT
(
P.3-6)
POST
Logical Seek (
P.3-7)
Overprint (
P.3-7)
Drying Time (
P.3-7)
Margin/L (
P.3-8)
Margin/R (
P.3-8)
Refresh (
P.3-8)
Host / OFF/ Weak/
Standard/ Strong
Vacuum Fan
Host
Continu
(
P.3-8)
Weak
ous
Standard
running
Strong
Feed speed
Print Speed
(
P.3-8)
Scan Speed
AUTO
MAPS4
Pattern
(
P.3-9)
MANUAL
Smoothing
Lv.
OFF, File, Length, Time
File
Interval 1 to 1000
Type
Auto Cleaning
Length
Interval 0.1 to 20.0 to 100.0m
(
P.3-9)
Type
Time
Interval 10 to 30 to 120 min
Type
Interval Wiping (
P.3-10)
Setup Reset (
P.3-5)
*1. The underlined has been set as default.
*2. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority to the setting value at
the machine side.
When no instruc-
*1
Set value
-9999 to 0 to 9999
-40.0 to 0 to 40.0
OFF/ 20 to 60 °C
(OFF/ 68 to 140°F)
Data / Media / Quality
Host / 1 to 9
Host / 0.0s to 9.9 sec
-10 to 85mm
Host / Lv.0 to Lv.3
ON/OFF
10 to 100 %
70 to 100 %
1 / 2 / 3
5 to 25 to 100%
Normal/ Soft/ Hard
Normal/ Soft/ Hard
Normal/ Soft/ Hard
3 to 255 min, OFF
The configulation in the settings 1-4 can be reset ondividually.
tion from RIP
*2
exists
Used to print a pattern for correcting a media-
feeding rate and correct it.
Used to adjust the dot position in go and return
printing.
Sets pre-heater's conditions.
Sets the scan movable area during printing.
Sets the number of layers in which ink is to be
1
applied.
0 sec
Set the ink drying time.
Sets a non-printing area along the right and left
edges of the media.
Sets the interval of refresh performed during
Lv.3
printing.
Standard
Sets the absorbability of the media.
Changes the media feeding speed in printing.
Change the travel speed of the carriage during
printing.
Perform setting to reduce stripes between passes.
Sets the automatic cleaning operation for the head
performed before printing or during printing.
Sets the wiping operation performed after printing
is completed.
Chapter 3 Setup
Outline
3-3
3
2
2
Advertisement
Table of Contents
