Setup Menu; Setup Menu Table - MIMAKI TxF150-75 Operation Manual

Chapter 3 Settings

Setup Menu

From the setup menu, you can set the print conditions for media you normally use.

Setup menu table

• Each of the following setting items can be configured for operation according to setting values used during RIP print-
ing from a connected host computer.
• Setting items: Drying time / Margin (left/right) / Vacuum / Feed speed level
• Set each item to "Host" for operation according to the RIP settings. To give priority to settings made on the machine,
use a setting other than "Host."
• For instructions on setting up RIP software, refer to the RIP software instruction manual.
Function name
FEED COMP. ( P.3-3)
DROP.POScorrect ( P.3-3)
HEATER PRE
( P.3-4)
PRINT
POST
Off Time
LOGICAL SEEK ( P.3-4)
DRYING SCAN
TIME
PRINT END
( P.3-4)
MARGIN / LEFT ( P.3-5)
MARGIN / RIGHT ( P.3-5)
VACUUM ( P.3-5)
*2
FEED SPEED ( P.3-5)
AUTO OFF, FILE,
CLEANING LENGTH, TIME
( P.3-5)
FILE
Length INTERVAL
TIME
Cleaning Check
INTERVAL WIPING (
MAPS AUTO
( P.3-5)
MANU Speed
AL
Smoothing
Level
SETUP RESET ( P.3-3)
*1. Setting values used for printing when no setting value is indicated by the RIP software (host), or if you give priority to setting values configured on
the machine.
*2. Set to 100% or more for faster printing, but note that sufficient drying time cannot be ensured, which may affect print quality.
3-2
Setting value
-9999 to 0 to 9999
-40.0 to 0 to 40.0
OFF / 20–50°C
NONE / 0–90 min.
HOST / ON / OFF
HOST / 0.0–9.9 sec.
HOST / 0–120 min.
-10 to 85 mm
HOST / WEAK /
STANDARD / STRONG
10 to 100 to 200％
INTERVAL 1–1000
TYPE NORMAL / SOFT / HARD
0.1–100.0 m
TYPE NORMAL / SOFT / HARD
INTERVAL 10–120 min.
TYPE NORMAL / SOFT / HARD
ON / OFF
3–255 min., OFF
P.3-6)
50–100%
0–100%
Settings 1-4 can be reset individually.
Without RIP
Description
*1
instructions
Used to print a pattern for correcting the
media feed amount and then correcting
it.
Used to adjust the drop position in
bidirectional printing.
Sets the temperature of each heater.
Sets the time until the heater is turned off
after printing.
ON Sets the scanning area during printing.
0 sec. Sets the time to wait for ink to dry.
0 min.
0 mm Sets a non-printing area along the right
and left edges of the media.
0 mm
STRONG Sets the vacuum strength for the media.
100% Changes the media feed speed in
printing and other tasks.
Sets operation of automatic head
cleaning before or during printing.
Sets whether to check the nozzles after
auto cleaning.
Sets operation of wiping performed
during printing.
Changes the effect of "MAPS."