Setting A Roll Media - MIMAKI JV400-LX Series Operation Manual

Setting a roll media

1
Move the roll holder located in the back of
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and then move it.
2
Check the clamp lever is lowered.
3
Move the roll holder to the roll setting position.
Roll Holder
Set Position
• There are two types of the internal diameter
of the roll media paper tube: 2 inch and 3
inch.
• Check the roll stopper is not caught between the roll stopper arm and this machine.
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll media on the
let roll holder.
• Push the roll media onto the roll holder until the roll core is all
the way seated.
6
Loosen the screw of the right side roll holder then
insert the holder into the core of the roll media.
2-8
Set the base posi-
tion of roll holder
within this range.
3 Inch Roll Media
2 Inch Roll Media
Roll holder
fixing screw
Roll holder
Basis
Setting position
of 3inch tube
3 Inch Roll Media
Roll Holder
Set Position
2 Inch Roll Media
Setting position
of 2inch tube
Roll Holder Side
(The back of this machine)
Roll holder