Setting A Roll Media - MIMAKI JV300-130 A Operation Manual

Setting a roll media

Set a roll media to the roll media hanger located on the
back of this machine.
Move the roll holder located in the back of
1
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and then move
it.
Roll holder
Lock screw
Check the clamp lever is lowered.
2
Move the roll holder to the roll setting
3
position.
• Check the roll stopper is not caught between the
roll stopper arm and this machine.
Set the base position of roll holder
within this range.
• There are two types of the internal diameter of the
roll media paper tube: 2 inch and 3 inch.
Setting position
of 2inch tube
Roll Holder Side (The back of this machine)
Roll holder
Base
Setting position
of 3inch tube
Chapter 2 Basic Operation
Tighten the roll holder fixing screw.
4
• Check the Step 2 to 3 again.
Set the left end of the core of the roll media
5
on the left roll holder.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
Loosen the screw of the right side roll
6
holder then insert the holder into the core
of the roll media.
Raise the clamp lever in the rear of this
7
machine.
2
2
2
5
6
2-5