Setting The Media Origin - MIMAKI JFX550-2513 Operation Manual

Chapter 2 Printing
Using the Positioning Tools
The following accessories are provided to allow the media to be loaded straight.
(1) Positioning pins (×10)
(2) Origin stickers (×8)
l Using the positioning pins
Guide holes are provided on the table surface for inserting the positioning pins. Attach the included
positioning pin to adjust the position at which media is loaded.
[Table]
[Print Area]
• You can use a commercially available M3 screw in place of the positioning pin provided.
l Using the origin stickers
The origin stickers can be used at positions on the table where you wish to load the media. The origin
stickers are useful when using thin media. Affix the origin stickers at the corners of the media as required for
loading the media.

Setting the Media Origin

Use the LED pointer to set the origin.
Change the origin as follows:
Check visually as you set the origin.
Enter a value to set the origin.
Rear side
For commercially available screws
200 mm
Front side
Pattern
"Visually Setting the Origin"(P. 63)
"Entering a Value to Set the Origin"(P. 64)
200 mm
200 mm
For the positioning pin
10 mm
Positioning pin (included)
Origin sticker
Item
62
5 mm
30 mm