Setting Leaf Media - MIMAKI JV330 Series Operation Manual

Chapter 2 Printing

Setting Leaf Media

• Leaf media cannot be used on JV/ TS.
• The roll holder is not used with leaf media.
1
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
• The Media Setting menu is displayed.
2
Select [Media Information] > [Media Operation Form] > [Leaf], then press the [ENTER] key.
• The media bottom end will not be detected if Leaf is not selected.
3
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
4
Raise the clamp lever.
5
Open the front cover.
6
Insert the media.
• Insert into the gap between the pinch rollers and the grit rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.
7
Adjust the position of the right media edge.
• Set the media straight so that the media does not lie beyond the slit line on the platen.
• The areas extending 5 mm from both sides of the media are margins.
First three grit rollers from the right end on the front of the machine
72