Setting The Media - MIMAKI UJF-3042 MkII Series Operation Manual

Chapter 2 Basic Operation
[END/POWER] key a long time on the front of the
machine, check the display is turned off on the
operation panel, and then turn the main power switch
off.
2-4

Setting the media

• The peripheral parts of the media could roll up due
to heat. Fix the media supplementary using
adhesive tapes, etc.
Setting the media thickness.
1
(1) Press the [FUNC1] (MENU)
[ENTER] key in LOCAL mode.
(2) Select "MEDIA THICKNESS", and press the
[ENTER] key.
(3) Press [][] to set the media thickness, and
press the [ENTER] key.
• When using a jig, enter the jig's height + the media
thickness.
• Place the media so that concentrated load is
prevented.
Setting the Table Height
If the table height is changed, Media Thickness is also
changed.
Press the
1
[] key in LOCAL mode.
• HEAD HEIGHT MENU will be displayed.
Press
2
HEIGHT" , and press the
Press
3
and press the
Set value : 0.0 to 153.0mm
• The value to be entered varies by the number of
table spacer.
Press the
4
end the setting.
[] (1 time)
(MENU)
to serect "TABLE
key.
to set the table height,
key.
key several times to