Setting Leaf Media (Cloth Media); Setting Leaf Media (Transfer Paper) (Tx300P-1800 Mkii Only); Setting Leaf Media (Transfer Paper); (Tx300P-1800 Mkii Only) - MIMAKI Tx300P-1800 Operation Manual

Setting leaf media (cloth media)

Unlike roll media, leaf media does not need to be retained
with the roll holders.
• Use the corresponding platen for cloth or paper
media. Check to confirm that the correct platen
has been mounted.（Tx300P-1800 MkII）
Set the FEEDING UNIT and TAKE-UP UNIT
1
to "OFF" in "Feeding/ Take-up device" of
the machine setup.(
Open the front cover, and then raise the
2
clamp lever.
Front cover
Insert the leaf media between the platen
3
and the pinch rollers, and push down the
clamp lever.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
Pinch roller
Hold the media with the fabric retainer
4
gently.
• Set the media so that it does not extend to the
right of the V-groove on the platen.
• When using a thick media, remove the fabric
retainer from the media before printing.
In this case, set the machine setup of "Setting the
Media Detection" to "MANUAL" (
refer to P.2-27 "Setting of the manual media width
setting" and set the media width.
fabric retainer
P.2-9)
Unlike roll media, leaf media does not need to be retained
with the roll holders.
P.3-16), and
Chapter 2 Basic Operation
Close the front cover.
5
• Set the media straight.
• For the leaf media, use only a withy one.
When using the leaf media, the take-up device is
invalid. If the set media is not withy, the printing
face will not become flat and the media will jam.
• Set media long enough to cover tension roller.
Otherwise, the media may be caught between
tension roller and the fabric roller and get jammed.
Press to select "LEAF" .
6
The media detection is started.
7
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.

Setting leaf media (Transfer Paper)

(Tx300P-1800 MkII only)

• Use the corresponding platen for cloth or paper
media. Check to confirm that the correct platen
has been mounted.（Tx300P-1800 MkII）
Set the FEEDING UNIT and TAKE-UP UNIT
1
to "OFF" in "Feeding/ Take-up device" of
the machine setup.(
Open the front cover, and then raise the
2
clamp lever.
Front cover
P.2-9)
2-25
2
2
2
5
6