Chapter 2 Printing
Positioning Pin
The guide holes on the table surface will let you load media straight to the table. Attach the included
positioning pin to adjust the position at which media is loaded.
[Table]
[Print Area]
• You can use a commercially available M3 screw in place of the positioning pin provided.
Setting the Media Origin
Use the LED pointer to set the origin.
Change the origin as follows:
Check visually as you set the origin.
Enter a value to set the origin.
Visually Setting the Origin
1
From QUICK MENU on the touch panel, touch [JOG operation].
• A dialog box appears.
• You can also visualize this as follows:
(1) From MENU on the touch panel, touch [SETTING 2].
(2) Touch [Media] > [JOG operation].
Rear side
For commercially available screws
200 mm
Front side
"Visually Setting the Origin"(P. 48)
"Entering a Value to Set the Origin"(P. 50)
200 mm
200 mm
For the positioning pin
10 mm
Positioning pin (included)
Item
48
5 mm
30 mm