Removing The Upper Fan Tray Cover; Removing The Interface Module Cage Cover - Juniper MX960 Hardware Manual

282
3. Gently push the cover down to secure it in place.

Removing the Upper Fan Tray Cover

The upper fan tray cover is installed below the craft interface and covers the upper fan tray. To remove
the upper fan tray cover, use the following procedure (see Figure 69 on page 280).
1. Rotate the latch knobs counterclockwise until the cover is released or until the knobs stop turning.
2. Remove the cover.

Removing the Interface Module Cage Cover

To remove the interface module cage cover, use the following procedure (see Figure 71 on page 282).
1. Press the cover catch release area marked with the instruction label on each side of the cover.
2. Slide the cover up until it stops; then pull the cover toward you to remove.
Figure 71: Removing the Interface Module Cage Cover