Frame-Relay Multilink Bandwidth-Class - Cisco ASR 9000 Series Command Reference Manual

frame-relay multilink bandwidth-class

frame-relay multilink bandwidth-class
To configure the bandwidth class for a Frame Relay multilink bundle interface, use the frame-relay multilink
bid bandwidth-class command in interface configuration mode. To restore the default setting, use the no
form of this command.
frame-relay multilink bandwidth-class {a| b| c threshold}
no frame-relay multilink bandwidth-class
Syntax Description
a
b
c
threshold
Command Default
The default is a (Bandwidth Class A).
Command Modes
Interface configuration
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Bandwidth class is configurable only under Frame Relay Forum 16.1 (FRF 16.1).
The frame-relay multilink bandwidth-class command is supported only on multilink frame relay
Note
interfaces. The frame-relay multilink bandwidth-class command is not supported on
Packet-over-SONET/SDH (POS) or serial interfaces.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
450
Configures bandwidth class A. When one or more member links are up, the bundle interface
is up. When all the member links are down, the bundle interface is down.
Configures bandwidth class B. When all the member links are up, the bundle interface is
up. When any member link is down, the bundle interface is down.
Configures bandwidth class C. The bundle link threshold must be configured.
Minimum number of links that must be up for the bundle interface to be up. The range is
1 to 255.
Frame Relay Commands on the Cisco ASR 9000 Series Router
Modification
This command was introduced.