Peer Ipv4 Address - Cisco ASR 9000 Series Command Reference Manual

PPP Commands onthe Cisco ASR 9000 Series Router

peer ipv4 address

To configure the IPv4 address for a Session State Redundancy Protocol (SSRP) peer, use the peer ipv4
address command in SSRP configuration mode. To remove the address, use the no form of this command.
peer ipv4 address ip-address
no peer ipv4 address ip-address
Syntax Description
ip-address
Command Default
No default behavior or values
Command Modes
SSRP configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ppp
Examples The following example shows how to configure the IPv4 address for a Session State Redundancy Protocol
(SSRP) peer:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# ssrp profile Profile_1
RP/0/RSP0/CPU0:router(config-ssrp)# peer ipv4 address 10.10.10.10
Related Commands
Command
ssrp profile, on page 774
IP address of the peer interface whose states will be replicated by SSRP.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Operations
read, write
Description
Configures a SSRP profile and enters the SSRP configuration
mode.
peer ipv4 address
Release 5.3.x
719