Ethernet Cfm (Interface) - Cisco ASR 9000 Series Command Reference Manual

Ethernet OAM Commands on the Cisco ASR 9000 Series Router

ethernet cfm (interface)

To enter interface CFM configuration mode, use the ethernet cfm (interface) command in interface
configuration mode.
ethernet cfm
Syntax Description
This command has no keywords or arguments.
Command Default
No MEPs are configured on the interface.
Command Modes
Interface configuration (config-if)
Subinterface configuration (config-subif)
Command History
Release
Release 3.9.1
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples
The following example shows how to enter interface CFM configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ethernet cfm
RP/0/RSP0/CPU0:router(config-if-cfm)#
Related Commands
Command
cos (CFM), on page 194
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Support for subinterface configuration mode was added.
Operations
read, write
Description
Configures the CoS for all CFM packets generated by the
MEP on an interface.

ethernet cfm (interface)

Release 5.3.x
209