show lacp port
show lacp port
To display detailed information about Link Aggregation Control Protocol (LACP) ports, enter the show lacp
port command in EXEC mode.
show lacp port [[GigabitEthernet| TenGigE] interface_instance]
Command Default
No default behavior or values.
Command Modes
EXEC mode
Command History
Release
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
bundle
Examples
The following example shows how to display LACP port information for all link bundles on a router:
RP/0/RSP0/CPU0:router# show lacp port
Flags: A - Device is in Active mode. P - Device is in Passive mode.
State: 0 - Port is Not Aggregatable. 1 - Port is Out Of Sync with peer.
Bundle-Ether1
B/W (Kbps)
----------
Port
------------
Gi0/0/2/0
PEER
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
656
S - Device sends PDUs at slow rate. F - Device sends PDUs at fast rate.
D - Port is using default values for partner information
E - Information about partner has expired
2 - Port is In Sync with peer. 3 - Port is Collecting.
4 - Port is Collecting and Distributing.
MAC address
--------------
0
0800.453a.651d
State
Flags
-----
-----
1
ASDE
0
PSD
Link Bundling Commands on the Cisco ASR 9000 Series Router
Modification
This command was introduced.
Operations
read
Minimum active
Maximum active
Links
B/W (Kbps)
Links
-----
----------
-----
1
620000
32
Port ID
Key
--------------
------
0x8000, 0x0001
0x0001
0xffff, 0x0000
0x0000
System-ID
-------------------------
0x8000, 08-00-45-3a-65-01
0xffff, 00-00-00-00-00-00