Clear Controller T3 - Cisco ASR 9000 Series Command Reference Manual

clear controller t3

clear controller t3
To clear T3 controller data, use the clear controller t3 command in EXEC configuration mode.
clear controller t3 interface-path-id
Syntax Description
interface-path-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
• When specifying a T3 controller, the naming notation is rack/slot/module/port/T3num. The slash between
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
964
Physical interface or virtual interface.
Use the show controllers command to see a list of all controllers currently
Note
configured on the router.
For more information about the syntax for the router, use the question mark (?) online
help function.
values is required as part of the notation. An explanation of each component of the naming notation is
as follows:
◦rack—Chassis number of the rack.
◦slot—Physical slot number of the line card or SIP.
◦module—Module number or subslot (for a SPA). A physical layer interface module (PLIM) is
always 0.
◦port—Physical port number of the interface.
◦T3num—T3 controller number.
To view the status of the controllers, use the show controllers t3 command.
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
Modification
This command was introduced.