Status-Counter - Cisco ASR 9000 Series Command Reference Manual

status-counter

status-counter

To set the Metro Ethernet Forum (MEF) N393 Status Counter value that is used to determine Ethernet Local
Management Interface (E-LMI) operational status, use the status-counter command in interface Ethernet
LMI configuration mode. To return to the default, use the no form of the command.
status-counter threshold
no status-counter threshold
Syntax Description
threshold
Command Default
The N393 Status Counter is set to 4.
Command Modes
Interface Ethernet LMI configuration (config-if-elmi)
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If the E-LMI protocol status is currently Up, the Status Counter specifies how many consecutive times the
PVT must expire before the status is changed to Down. If the E-LMI status is currently Down, the Status
Counter specifies how many STATUS ENQUIRY messages must be received without the PVT expiring
before the status is changed to Up. If the PVT is disabled, the status counter has no effect.
Task ID
Task ID
ethernet-services
Examples
The following example shows how to set the MEF Status Counter for E-LMI to 6:
RP/0/RSP0/CPU0:router# interface gigabitethernet 0/1/0/0
RP/0/RSP0/CPU0:router(config-if)# ethernet lmi
RP/0/RSP0/CPU0:router(config-if-elmi)# status-counter 6
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
404
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Number from 2 to 10. The default is 4.
Modification
This command was introduced.
Operation
read, write