g709 fec
The G.709 wrapper must be enabled to enable forward error correction (FEC) mode on the controller.
Standard FEC is the default mode; therefore, if you use the no g709 fec command, standard FEC is used.
To display the FEC mode, use the show controller dwdm command.
Task ID
Task ID
dwdm
Examples
This example shows how to configure the FEC mode on a DWDM controller:
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/6/0/0
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state out-of-service
RP/0/RSP0/CPU0:router(config-dwdm)# commit
RP/0/RSP0/CPU0:router(config-dwdm)#
RP/0/RSP0/CPU0:router(config-dwdm)# commit
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state in-service
RP/0/RSP0/CPU0:router(config-dwdm)# commit
Related Commands
Command
admin-state, on page 3
show controller dwdm, on page 56
g709 bdi-to-client-gais, on page 7
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
10
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
Operations
read, write
g709 fec standard
Description
Configures the transport administration state on a DWDM port.
Displays optical parameters, G.709 alarms and counters, and
register and module information for a DWDM controller.
Inserts a GAIS pattern to client on the detection of a BDI.