Frame-Relay Multilink Bid - Cisco ASR 9000 Series Command Reference Manual

frame-relay multilink bid

frame-relay multilink bid
To create a name for a Frame Relay multilink bundle interface, use the frame-relay multilink bid command
in interface configuration mode. To restore the default setting, use the no form of this command.
frame-relay multilink bid bundle-id-name
no frame-relay multilink bid
Syntax Description
bundle-id-name
Command Default
By default, the interface name, for example, Multilink 0/4/1/0/1, is used as the bundle identifier.
Command Modes
Interface configuration
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay multilink bid command is supported only on multilink frame relay interfaces. The
Note
frame-relay multilink bid command is not supported on Packet-over-SONET/SDH (POS) or serial
interfaces.
Regardless of whether you create a bundle identifier name using the frame-relay multilink bid command or
whether the system uses the default name for the interface, each bundle should have a unique name.
Task ID
Task ID
fr
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
452
Name for the Frame Relay multilink bundle. The bundle identifier (bid) name identifies
the bundle interface at both endpoints. The bid name is exchanged in the information
elements to ensure consistent link assignments. The bid name can be up to 50 characters
including the null termination character. The bid name is configured at the bundle interface
level and is applied to each member link.
Modification
This command was introduced.
Operations
read, write
Frame Relay Commands on the Cisco ASR 9000 Series Router