Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

show ethernet lmi interfaces
Table 20: show ethernet lmi interfaces detail Field Descriptions
Field
Interface:
Ether LMI Link Status:
UNI Id:
Line Protocol State:
MTU (x PDUs reqd for full report)
CE-VLAN/EVC Map Type: type (x EVCs)
Configuration: Status counter
Polling Verification Timer
Last Data Instance Sent:
Last Sequence Numbers: Sent x, Received y
Reliability Errors:
(Status Enq Timeouts, Invalid Report Type, and
Invalid Sequence Number)
Protocol Errors:
(Malformed PDUs, Invalid Message Type, Duplicated
IE, and others)

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x
360
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Description
Name of the interface running the E-LMI protocol.
Status of the E-LMI protocol on the interface. Possible
values are Up, Down, or Unknown (PVT disabled).
Name of the UNI as configured by the ethernet uni
id command. This output field does not appear if the
UNI ID is not configured.
Status of the interface line protocol. Possible values
are Up, Down, or Admin-Down.
Maximum Transmission Unit of the interface and the
number (x) of E-LMI PDUs of that size required to
send one full status report.
Map type, which describes how CE VLAN IDs are
mapped to specific EVCs. Possible valued for type
are Bundling, All to One Bundling, or Service
Multiplexing with no bundling. The number x of
EVCs in the map are displayed in parentheses.
Value of the MEF N393 Status Counter as configured
by the status-counter command.
Value of the MEF T392 Polling Verification Timer
(in seconds) as configured by the
polling-verification-timer command. Displays
"disabled" if the PVT is turned off.
Current value of the Data Instance.
Values of the last sent (x) and received (y) sequence
numbers as reported in sent PDUs.
Number of times the specified types of reliability
errors have occurred since the protocol was enabled
on the interface or counters were cleared.
Number of times the specified types of protocol errors
have occurred since the protocol was enabled on the
interface or counters were cleared.