Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

show ethernet lmi interfaces
Field
OAM Protocol:
CFM Domain:
CFM Service:
Remote UNI Count: Configured = x, Active = y
Remote UNI Id:
Status
Related Commands
Command
clear ethernet lmi interfaces, on page 175

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x
362
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Description
The OAM protocol from which the EVC status and
type are derived. Possible values are either "CFM"
or "None."
Name of the CFM domain for this EVC.
Name of the CFM service for this EVC.
Number of configured or expected remote UNIs (x)
and the number of active remote UNIs (y) within the
EVC.
ID of each remote UNI, including both configured
and active remote UNIs where these two sets are not
identical. If the number of configured and active
remote UNIs is zero, no table is displayed.
Note Where no ID is configured for a remote UNI
using the ethernet uni id command, then
the CFM remote MEP ID is displayed, for
example, "<Remote UNI Reference Id: x>"
Status of each remote UNI, with the following
possible values: "Up," "Down," "Admin Down,"
"Unreachable (a configured remote UNI is not active
or missing)," or "Unknown (a remote UNI is active
but not reporting its status)."
Description
Clears Ethernet LMI statistics on one or all interfaces.