Hw-Module Load-Balance Bundle L2-Service L3-Params - Cisco ASR 9000 Series Command Reference Manual

hw-module load-balance bundle l2-service l3-params

hw-module load-balance bundle l2-service l3-params
Effective with Cisco IOS XR Release 4.0.1, the hw-module load-balance bundle l2-service l3-params
Note
command is replaced by the load-balancing flow L2VPN configuration command. See the load-balancing
flow command in the Cisco ASR 9000 Series Aggregation Services Router L2VPN and Ethernet Services
Command Reference for more information.
To configure load balancing for L2 services using L3 parameters, use the hw-module load-balance bundle
l2-service l3-params command in global configuration mode. To disable load balance L2 services, use the
no form of this command.
hw-module load-balance bundle l2-service l3-params
no hw-module load-balance bundle l2-service l3-params
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
Release
Release 3.9.1
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command enables the L2 service-specific load-balancing for bundle Ethernet Flow Points (EFPs). By
default, bundle load-balancing is done based on the MAC SA/DA fields in the packet header. When L2
service-specific load-balancing is configured, all traffic egressing bundle EFPs are load-balanced based on
the IPv4 source and destination addresses in the packet. If the packet does not have IPv4 addresses, the default
load-balancing is used.
Task ID
Task ID
root-lr
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
588
Link Bundling Commands on the Cisco ASR 9000 Series Router
Modification
This command was introduced.
This command was replaced by the load-balancing flow command.
Operations
read, write