Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

Integrated Routing and Bridging Commands on the Cisco ASR 9000 Series Router
Examples
The following example shows sample output for the show interfaces bvi command:
RP/0/RSP0/CPU0:router# show interfaces bvi 50
Wed Feb 16 16:05:11.508 PST
BVI50 is up, line protocol is up
Interface state transitions: 3
Hardware is Bridge-Group Virtual Interface, address is 0000.0000.0002
Description: IRB Routed Example
Internet address is 172.16.0.1/24
MTU 9014 bytes, BW 10000000 Kbit (Max: 10000000 Kbit)
Encapsulation ARPA,
ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:37, output 00:00:00
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Table 37: show interfaces bvi Field Descriptions
Field
BVIx is
line protocol is
Interface state transitions:
Hardware is
address is
Description:
Internet address is n.n.n.n/n
reliability 255/255, txload 0/255, rxload 0/255
loopback not set,
25643 packets input, 1641152 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 25445 multicast packets
208 packets output, 9472 bytes, 0 total output drops
Output 8 broadcast packets, 0 multicast packets

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Description
Displays the state of the specified BVI interface,
where x is the number of the interface. The possible
values are: administratively down, down, or up.
Displays the stateof the line protocol for the BVI
interface. The possible values are: administratively
down, down, or up.
The line protocol state is not the same as the
Note
protocol state displayed in the show ip
interfaces command, because it is the state
of Layer 2 (media) rather than Layer 3 (IP
protocol).
Displays the number of times the interface has
changed states.
Displays Bridge-Group Virtual Interface for a BVI.
Layer 2 MAC address of the BVI.
Displays the description of the interface when
configured.
Layer 3 IP address of the BVI in dotted decimal
format.
show interfaces bvi
Release 5.3.x
559