Link-Monitor - Cisco ASR 9000 Series Command Reference Manual

link-monitor

link-monitor

To enter Ethernet OAM link monitor configuration mode, use the link-monitor command in Ethernet OAM
configuration mode. To enter interface Ethernet OAM link monitor configuration mode, use the link-monitor
command in interface Ethernet OAM configuration mode.
link-monitor
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples
This example shows how to enter the Ethernet OAM link monitor configuration mode.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)#
The following example shows how to enter the link monitor configuration mode from interface Ethernet OAM
configuration mode.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
RP/0/RSP0/CPU0:router(config-if-eoam)# link-monitor
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
262
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Modification
This command was introduced.
Operations
read, write