Polling-Verification-Timer - Cisco ASR 9000 Series Command Reference Manual

polling-verification-timer

polling-verification-timer

To set or disable the Metro Ethernet Forum (MEF) T392 Polling Verification Timer (PVT) for Ethernet Local
Management Interface (E-LMI) operation, use the polling-verification-timer command in interface Ethernet
LMI configuration mode. To return to the default, use the no form of the command.
polling-verification-timer {interval| disable}
no polling-verification-timer {interval| disable}
Syntax Description
interval
disable
Command Default
The T392 Polling Verification Timer is set to 15 seconds.
Command Modes
Interface Ethernet LMI configuration (config-if-elmi)
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The PVT specifies the allowable time between transmission of a STATUS message and receipt of a STATUS
ENQUIRY from the Customer Edge (CE) device before recording an error. If the PVT expiration time is
reached on consecutive packets for the number of times specified by the status-counter command without a
STATUS ENQUIRY being received, the E-LMI protocol status is changed to Down.
Task ID
Task ID
ethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
294
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Number of seconds in the range 5 to 30. The default
is 15.
Turns off the timer.
Modification
This command was introduced.
Operation
read, write