Bert E1 - Cisco ASR 9000 Series Command Reference Manual

bert e1

bert e1
To start or stop a configured bit error rate test (BERT) on an E1 controller or channel group, use the bert e1
command in EXEC mode. To return to the default state, use the no form of this command.
bert e1 interface-path-id [channel-group channel-group-number] [error] {start| stop}
Syntax Description
interface-path-id
channel-group
channel-group-number
error
start
stop
Command Default
No default behavior or values
Command Modes
EXEC
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
• If specifying a physical interface, the naming notation is rack/slot/module/port. The slash between values
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
938
Physical interface or virtual interface.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
(Optional) Channel group number. When an E1 data line is configured, channel
group numbers can be values from 0 to 30.
Note
(Optional) Injects errors into the running BERT stream.
Starts the BERT on the E1 controller or channel.
Stops the BERT on the E1 controller or channel.
is required as part of the notation. An explanation of each component of the naming notation is as follows:
◦ rack: Chassis number of the rack.
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
For any of the DS0 time slots within the time slot range provided for
the channel group, use time slot -1 as the channel number.
Modification
This command was introduced