Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Syntax Description
priority number
send packet once
send packet every number {milliseconds | seconds | minutes | hours}
send burst once
send burst every number {seconds | minutes | hours}}
packet count number
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
ethernet sla on-demand operation type cfm-delay-measurement probe
(Optional) Configures the priority
of outgoing SLA probe packets.
The range is 0 to 7. The default is
to use the COS bits for the egress
interface.
(Optional) Sends one packet one
time.
(Optional) Sends one packet every
specified number of milliseconds,
seconds, minutes, or hours, where
number is in the following range:
• 1 to 3600 seconds
• 1 to 1440 minutes
• 1 to 168 hours
• 100 to 10000 milliseconds
(specified in increments of
100)
(Optional) Specifies that a burst of
packets is sent one time. This is the
default.
(Optional) Sends a burst of packets
every specified number of seconds,
minutes, or hours, where number
is in the following range:
• 1–3600 seconds
• 1–1440 minutes
• 1–168 hours
The default is to send a burst every
10 seconds.
Specifies the number of packets to
be sent in a burst, in the range 2 to
600. The default is 10.
Release 5.3.x
225