Frame-Relay Lmi-N393Dte - Cisco ASR 9000 Series Command Reference Manual

Frame Relay Commands on the Cisco ASR 9000 Series Router

frame-relay lmi-n393dte

To set the monitored event count on a DTE interface, use the frame-relay lmi-n393dte command in interface
configuration mode. To restore the default setting, use the no form of this command.
frame-relay lmi-n393dte events
no frame-relay lmi-n393dte events
Syntax Description
events
Command Default
The number of DTE monitored events is 4.
Command Modes
Interface configuration
Command History
Release
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The frame-relay lmi-n393dte command is relevant only when the interface type is data terminal equipment
(DTE).
This frame-relay lmi-n393dte command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
Task ID
Task ID
fr
Examples
The following example shows how to set the Local Management Interface (LMI) monitored events count to
5.
RP/0/RSP0/CPU0:router(config)# interface pos 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# frame-relay intf-type dte
RP/0/RSP0/CPU0:router(config-if)# frame-relay lmi-n393dte 5
Monitored events count. Range is from 1 to 10. The default is 4.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Operations
read, write
frame-relay lmi-n393dte
Release 5.3.x
441