Remote-Loopback - Cisco ASR 9000 Series Command Reference Manual

Ethernet OAM Commands on the Cisco ASR 9000 Series Router

remote-loopback

To enable a remote loopback on the far end of an Ethernet OAM interface, use the remote-loopback command
in Ethernet OAM configuration or interface Ethernet OAM configuration mode. To return the interface to the
default (disabled), use the disable keyword.
remote-loopback [disable]
Syntax Description
disable
Command Default
Remote loopback is disabled by default.
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When remote loopback is enabled on an Ethernet OAM interface, the OAM client advertises support for
remote loopback to the peer.
When remote loopback is disabled (the default), only the enable form of the remote-loopback command is
available in interface Ethernet OAM configuration mode. The disable keyword is provided to override the
profile when needed.
Task ID
Task ID
ethernet-services
Examples The following example shows how to enable remote loopback on a Gigabit Ethernet interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/5/6
RP/0/RSP0/CPU0:router(config-if)# ethernet oam
Disables the remote loopback at the far end of the Ethernet OAM interface.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Operations
read, write

remote-loopback

Release 5.3.x
303