Sts - Cisco ASR 9000 Series Command Reference Manual

sts

sts
To specify the Synchronous Transport Signal (STS) path and enter the STS controller configuration mode,
use the sts command in SONET controller configuration mode.
sts number
Syntax Description
number
Command Default
No default behavior or values
Command Modes
SONET controller configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
sonet-sdh
Examples
The following example shows how to specify STS 1:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/1/0/0
RP/0/RSP0/CPU0:router(config-sonet)# sts 1
RP/0/RSP0/CPU0:router(config-stsPath)#
Related Commands
Command
au, on page 844
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
920
SONET Controller Commands on the Cisco ASR 9000 Series Router
STS path number. The range varies by the type of line card.
Modification
This command was introduced.
Operations
read, write
Description
Specifies the administrative unit (AU) group number and enters the AU
controller configuration mode.