Ethernet Lmi - Cisco ASR 9000 Series Command Reference Manual

Ethernet OAM Commands on the Cisco ASR 9000 Series Router

ethernet lmi

To enable Ethernet Local Managment Interface (E-LMI) operation on an interface and enter interface Ethernet
LMI configuration mode, use the ethernet lmi command in interface configuration mode. To disable Ethernet
LMI and return to the default, use the no form of the command.

ethernet lmi

no ethernet lmi
Syntax Description
This command has no keywords or arguments.
Command Default
Ethernet LMI is disabled.
Command Modes
Interface configuration (config-if)
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Ethernet LMI is supported only on physical Ethernet interfaces.
Task ID
Task ID
ethernet-services
Examples The following example shows how to enable Ethernet LMI on a Gigabit Ethernet interface and enter Ethernet
LMI configuration mode:
RP/0/RSP0/CPU0:router# interface gigabitethernet 0/1/0/0
RP/0/RSP0/CPU0:router(config-if)# ethernet lmi
RP/0/RSP0/CPU0:router(config-if-elmi)#
Related Commands
Command
interface (Ethernet), on page 85
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Modification
This command was introduced.
Operation
read, write
Description
Specifies or creates an Ethernet interface and enters interface
configuration mode.
ethernet lmi
Release 5.3.x
211