Lldp Reinit - Cisco ASR 9000 Series Command Reference Manual

lldp reinit

lldp reinit

To specify the length of time to delay initialization of the Link Layer Discovery Protocol (LLDP) on an
interface, use the lldp reinit command in global configuration mode. To return to the default, use the no form
of this command.
lldp reinit seconds
no lldp reinit seconds
Syntax Description
seconds
Command Default
Initialization of LLDP is delayed for 2 seconds on an interface.
Command Modes
Global configuration (config)
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples The following example shows how to change the default initialization delay from 2 to 4 seconds:
RP/0/RSP0/CPU0:router(config)# lldp reinit 4
Related Commands
Command
lldp, on page 87
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
92
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
Number from 2 to 5 that specifies the length of time (in seconds) that LLDP should
delay initialization. The default is 2.
Modification
This command was introduced.
Description
Enables LLDP globally for both transmit and receive operation on
the system.
Operation
read, write