Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

show controller dwdm
Field
Status
Dispersion Setting
Reroute Control
Reroute BER
See Table 3: show controllers dwdm optics Command Output Field Descriptions, on page 60
of the optics fields.
The following example shows the output from the show controllers dwdm command with the optics keyword:
RP/0/RSP0/CPU0:router# show controllers dwdm 0/2/0/0 optics
Mon Jul 12 21:04:29.254 UTC
Optics Status
This table describes selected fields from the show controllers dwdm command output with the optics keyword.
Table 3: show controllers dwdm optics Command Output Field Descriptions
Field
Optics Type
Clock Source
Wavelength Band
MSA ITU Channel
Frequency
Wavelength
TX power
RX Power

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x
60
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
Optics Type: 10GBASE-ZR,
Wavelength Info: C-Band, MSA ITU Channel= N/A, Frequency=192THz, Wavelength=1558nm
TX Power = 1.50 dBm
RX Power = -11.86 dBm
Description
Indicates whether the tunable dispersion compensator
(TDC) is in the acquiring state or locked state. The
status is invalid if there is a major alarm.
Indicates a value between –700 and +700 packets per
second (pps). The dispersion setting is read from the
optics module after the tunable dispersion
compensator (TDC) has locked.
Not used.
Not used.
Description
Indicates the optics type: GE or OC-768c/STM-256c
DWDM.
Indicates whether the clock is internal or line.
Indicates the wavelength band: C-band or L-band.
Multi Source Agreement (MSA) ITU channel number.
Frequency of the channel in terahertz.
Wavelength corresponding to the channel number in
nanometers.
Value of the transmit power level.
Actual optical power at the RX port.
for a description