Symbol-Period Window - Cisco ASR 9000 Series Command Reference Manual

symbol-period window

symbol-period window

To configure the window size for an Ethernet OAM symbol-period error event, use the symbol-period window
command in Ethernet OAM link monitor or interface Ethernet OAM link monitor configuration mode. To
return the window size to the default value, use the no form of this command.
symbol-period window window
no symbol-period window window
Syntax Description
window
Command Default
The default value is 1000.
Command Modes
Ethernet OAM link monitor configuration (config-eoam-lm)
Interface Ethernet OAM link monitor configuration (config-if-eoam-lm)
Command History
Release
Release 3.9.0
Usage Guidelines
The IEEE 802.3 standard defines the window size as a number of symbols rather than a time duration. These
two formats can be converted either way by using a knowledge of the interface speed and encoding.
Task ID
Task ID
ethernet-services
Examples The following example shows how to configure the window size for a symbol-period error.
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# symbol-period window 60000
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
408
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Size of the window for symbol-period error in milliseconds. The range is 1000
to 60000.
Modification
This command was introduced.
Operations
read, write