Bandwidth (Policy-Map Class) - Cisco MWR 2941 Command Reference Manual

bandwidth (policy-map class)

bandwidth (policy-map class)
To specify or modify the bandwidth allocated for a class belonging to a policy map, or to enable ATM
overhead accounting, use the bandwidth command in policy-map class configuration mode. To remove
the bandwidth specified for a class or disable ATM overhead accounting, use the no form of this
command.
Syntax Description
bandwidth-kbps
remaining percent
percentage
percent percentage
Command Default No bandwidth is specified.
ATM overhead accounting is disabled.
Command Modes
Policy-map class configuration (config-pmap-c)
Command History Release
12.0(5)T
12.0(5)XE
12.0(7)T
12.0(17)SL
12.0(22)S
12.0(23)SX
12.1(5)T
12.2(2)T
12.2(28)SB
12.2(31)SB
12.2(31)SB2
12.2(33)SRA
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
22
bandwidth {bandwidth-kbps | remaining percent percentage | percent percentage}
no bandwidth
Amount of bandwidth, in kilobits per second (kbps), to be assigned to the
class. The amount of bandwidth varies according to the interface and platform
in use.
Percentage of guaranteed bandwidth based on a relative percent of available
bandwidth. The range is from 1 to 100.
Percentage of guaranteed bandwidth based on an absolute percent of available
bandwidth to be set aside for the priority class. The range is from 1 to 100.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.0(5)XE and was
implemented on Versatile Interface Processor (VIP)-enabled Cisco 7500
series routers.
The percent keyword was added.
This command was introduced on the Cisco 10000 series router.
Support for the percent keyword was added on the Cisco 10000 series router.
Support for the remaining percent keyword was added on the Cisco 10000
series router.
This command was implemented on VIP-enabled Cisco 7500 series routers.
The remaining percent keyword was added.
This command was integrated into Cisco IOS Release 12.2(28)SB.
This command was implemented on the Cisco 10000 series routers.
This command was introduced on the PRE3 for the Cisco 10000 series router,
and was enhanced for ATM overhead accounting on the Cisco 10000 series
router for the PRE3.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
Cisco MWR 2941 Router Command Reference, Release 15.0(1)MR
OL-23890-01